Download PDF     Email this page

Hot Work Permit Program

Hot work is defined as any operation that involves or generates open flames, sparks or heat that could become a fire hazard. Examples include cutting, welding, grinding, torch-applied roof covers, soldering, etc. A permit should be completed when conducting hot work operations outside a permanent designated area.

The permit should be completed by a person in charge, such as the supervisor, who should:

  • Establish fire watch precautions
  • Inspect the worksite and check the precaution before signing the permit authorizing the work and allowing the operation to proceed.
A continuous fire watch while the operation is active and for at least 30 minutes after work has ceased should be provided. The fire watch should include the immediate work area and the floor above and below. The fire watch should also be active if the work is temporarily stopped for a break or any other reason. Fire extinguishers and/or a charged small hose must be available in the fire watch areas. Fire watch person(s) must be trained to use fire extinguisher or hose and to sound the fire alarm.

For more information and a sample permit, download the attached Sample Hot Work Permit.

Sample Hot Work Permit Checklist

Sprinklers are in service
Cutting and welding equipment in good repair/inspected

Precautions Within 35 Feet of Work

Floors swept clean of combustibles
Combustible floors wet down, covered with damp sand or fire resistive material
Flammable liquids removed
Combustibles not removed protected with fire resistive tarpaulins or metal shields
All wall and floor openings covered with fire resistant tarpaulins or metal shields

Work on Walls or Ceilings

Fire resistive tarpaulins suspended beneath work
Enclosed equipment cleaned of all combustibles
Containers purged of flammable liquids or removed from area
Combustibles moved away from other side of wall
Construction is non-combustible including coverings or insulation

Fire Watch

Fire watch will be provided during and for at least 30 minutes after work is completed and during all breaks
Fire watch is supplied with suitable extinguishers or charged small fire hose
Fire watch has been trained in the use of fire fighting equipment and emergency procedures

The recommendation(s), advice and contents of this material are provided for informational purposes only and do not purport to address every possible legal obligation, hazard, code violation, loss potential or exception to good practice. The Hanover Insurance Company and its affiliates and subsidiaries (“The Hanover”) specifically disclaim any warranty or representation that acceptance of any recommendations or advice contained herein will make any premises, property or operation safe or in compliance with any law or regulation. Under no circumstances should this material or your acceptance of any recommendations or advice contained herein be construed as establishing the existence or availability of any insurance coverage with The Hanover. By providing this information to you, The Hanover does not assume (and specifically disclaims) any duty, undertaking or responsibility to you. The decision to accept or implement any recommendation(s) or advice contained in this material must be made by you.
LC 11-399